XJ Rear Coil Conversion Brackets
For years leaf springs have done a great job of giving the Cherokee XJ a stable and simple rear suspension platform. Sadly, for the avid off-road enthusiast, wheel travel and articulation have been limited greatly by the leafs. As always the jeep nerds here at Ironman4x4fab.com have taken a current but incomplete idea and made it into a simple cut and weld system that allows for a 5" coil (any WJ 99-04 grand Cherokee front coil) to easily be installed and retained with coil clamps. The coils ride on rubber isolators for a smooth, quiet, and predictable suspension.
The main bracket notches into the rear chassis and welds in wherever the builder chooses for wheelbase location. It has face gussets built in to allow for rear stiffness and surface area strength. The upper plate has 2 hole patterns laser cut into it allowing for our internal air bump and ride height tuning kit. This kit also includes 2 lower coil mounts all made from 1/4" laser cut steel with coil retention mounts as well. Coils not included. 99-04 wj front coils from 4.0 engine offer 4.5" of lift with this kit. Fully retained, this coil more than doubled the rear wheel travel over leaf springs. This kit works with fram stiffeners but will need to be cut into just as the chassis to fit.
- x2 Weld in coil brackets.
- x2 Upper retention plates.
- x2 Axle side coil mounts with retention mounts.
- x4 rubber isolators
- x4 coil retainers 8- 1/2-13 countersunk socket head screws and serrated flange nuts.
- x4 5/8-18 grade 8 coil retainer bolts.
Coil Springs are not included with this kit.