My Cart

Close

Ironman4x4fab LLC

MJ OTA Track Bar

$290.00 USD

This track bar is designed for those who are running Over The Knuckle Steering and want to raise their track bar to match their draglink geometry and length. We have Over The Axle Track Bar Mounts for the Axle and an Offset Track Bar Bracket for the frame. This allows you to run a longer track bar to better match the draglink, helping eliminate the unwanted bumpsteer. Perfect for those doing the WJ Knuckle Swap. 

Our Track Bar is constructed from 1.25" high carbon (1043) steel that is cold-formed with welded and forged axle end bushing shell. It offers 6" of 1.25x12 thread single point machined directly on bar itself. No die threading for weak threads. NO OTHER COMPANY USES THIS MUCH THREAD! The Adjuster sleeve made from 1.75x.281 DOM steel fully pulse MIG welded to 2.625" wide Enduro Joint. We use a Barnes4wd Enduro Joint allowing for 40-degree offset use for stretched front ends.

Designed for 3" of lift and above.  Note: lifts under 4.5 inches must maintain proper bump stopping to clear all parts during complete suspension compression. 

Add Over The Axle Mount

The OTA Mount replaces and raises the axle side track bar mount to accommodate for the elevated track bar and help maintain good geometry in relation to your Over The Knuckle Steering setup. Its a must for higher lifts with OTK steering. 

Add Frameside Track Bar Bracket

Our OTA Track Bar is designed to fit our double shear track bar brackets. They are 2 5/8” and accept 9/16 hardware. Constructed out of 1/4” 100,000psi steel. 

Join our Subscription List!

Get special offers and discounts!